News

Why Does Activated Alumina Produce Dust During Use?

Nov 16, 2026 Leave a message

Insufficient Mechanical Strength of Activated Alumina

If the product does not have sufficient mechanical strength, its particles are prone to surface wear and edge chipping during long-term operation, and may even break into smaller particles, thereby generating dust.

Activated alumina is generally required to operate continuously for extended periods in compressed air dryers, natural gas dehydration units, and large industrial adsorption towers. Therefore, particle strength and abrasion resistance are particularly important.

Excessive Gas Flow Velocity or Uneven Gas Distribution

When the gas flow velocity inside the equipment is too high, the gas flow may cause particles to move, collide, and rub against one another, increasing surface wear. If the gas is not distributed evenly, localized high-velocity gas flow may occur in certain areas, causing stronger impacts on the activated alumina particles.

For dual-tower compressed air dryers and other gas purification equipment that use activated alumina as a desiccant, the operating gas velocity should be properly controlled, and the gas should be distributed evenly through the adsorbent bed.

Improper Loading of Activated Alumina

If particles fall freely from a considerable height during loading or are subjected to excessive impact, they may be damaged even before the equipment begins operating. In addition, if the bed is loaded unevenly, localized gas channels may form during operation, causing some particles to be continuously subjected to impact and friction.

Therefore, unnecessary dropping and mechanical impact should be minimized when loading activated alumina. The loading height and bed structure should be controlled in accordance with equipment requirements, and the support layer and gas distribution devices should be checked to ensure that they are functioning properly.

Frequent Pressure Changes and Regeneration Operations

Frequent pressure changes may subject the particles to repeated mechanical stress. If the equipment is improperly designed, pressure changes occur too rapidly, or the regeneration gas flow rate is not properly controlled, friction and collisions between particles may increase.

For drying systems that require repeated regeneration, attention should be paid not only to the adsorption performance of activated alumina, but also to its mechanical strength, abrasion resistance, and particle integrity after long-term cyclic use.

How Can Dust During the Use of Activated Alumina Be Reduced?

To reduce dust generation during the operation of activated alumina in industrial equipment, products with high mechanical strength, low attrition, and uniform particle size should be selected first. In addition, suitable particle specifications should be chosen according to the equipment type, gas flow rate, operating pressure, and regeneration method, so as to avoid increased operating resistance or particle wear caused by an inappropriate particle size.

During equipment installation, appropriate loading methods should be used to prevent excessive impact on the particles. At the same time, the gas distribution devices, support structure, and filtration system should be inspected to prevent localized high-velocity gas flow and particle fragments from entering downstream pipelines.

For adsorption equipment operating over long periods, the condition of the adsorbent bed, the pressure differential across filters, and equipment operation should also be checked regularly. If a noticeable increase in dust, abnormal pressure drop, or severe particle breakage is observed, the cause should be investigated promptly, and whether the adsorbent needs to be replaced should be determined according to the actual situation.

Zibo Xiangrun Environmental Engineering Co., Ltd. is a professional alumina manufacturer with more than ten years of production experience. The company offers activated alumina products in various specifications and can customize particle sizes and relevant technical parameters according to the needs of different industrial applications. Our activated alumina products focus on particle uniformity, mechanical strength, low attrition, and stable adsorption performance, and are suitable for various industrial gas drying and purification systems.

If you are looking for activated alumina for compressed air dryers, natural gas dehydration units, or air separation equipment, please feel free to contact Zibo Xiangrun.

 

22

Send Inquiry